The electronics basics training program is designed for beginners to understand electrical and radio engineering.
The electronics basics training program is designed for beginners to understand electrical and radio engineering.
The basic knowledge that you will receive in the course on electronics will be useful when repairing any electronic device (mobile phone, laptop, personal computer, video card or integrated circuits for mining).
After studying the electronics course, you will be able to repair any electronics freely.
Types of resistors
What LEDs look like
Types of transistors
Interface buses are designed to exchange information between the microcontroller (Master) and peripheral devices (Slave). In the electronics course, you will learn the main existing tires:
You will learn how to check communication using an oscilloscope by seeing the waveforms. Consider the START/STOP bits for the start and end of a data transfer used on buses. Learn the purpose of different tires in electronic devices.
Oscilloscope setup
During training, not only connections are considered, but also the correctness of performing mathematical calculations. In the course, you will become familiar with the parallel, series, mixed connection of resistors and capacitors. Coils, transformers, chokes are considered. And also the use of the above elements in schematic diagrams.
The internal resistance of the capacitor should tend to zero. During long-term operation, the resistance of the capacitor increases, the capacitive parameter of the device deteriorates due to the additional resistance that appears.
The electronics course examines the equivalent circuit of a capacitor. During the training, we will get acquainted with ESR, you will find out why this parameter is important for a capacitor.
You will get acquainted with the operation of logic circuits-AND-OR-NOT and others. Learn triggers: T, D, RS, JK. You will learn the logic of operation of multiplexers, decoders, microcontrollers, and other microcircuits. Learn the concept of logic, binary and hex codes.
While learning the basics of electronics, we learn the following basic bases:
The structure of bipolar, field-effect transistors is studied in detail. The physics of the transistor is explained. Then, in practice, the construction of the simplest circuits based on transistors. Learn bump test algorithms using measuring instruments. We focus on the study of p-n junctions.
Basic instruments with which you will learn how to take measurements:
Undoubtedly. In the electronics course, you will become familiar with the binary and hexadecimal number systems. Learn to translate one system to another, which will be needed to study microprocessors. Learn the acceptable levels of logical ones and zero. During the lesson, learn how to build circuits with logic control.
In the electronics course, you study photodetectors (photodiodes, phototransistors, photoresistors, etc.) optocouplers, characteristics and principle of operation, as well as the field of application. Learn how optical elements galvanically isolate secondary and primary circuits.
Examine electric vacuum devices. Consider the operation of pentodes, triodes, diodes in an electric vacuum design. Understand the principle of operation of these devices, including in sound technology (ULF)
Choke transformers, inductors and other elements will be considered. Equivalent circuits for their replacement, logic of functioning, electrical calculations. The use of a choke when the backlight driver is running.
Laptop diagnostics, multimeter measurements, oscilloscope – troubleshooting, laptop soldering
In the training program, diagnostics and common malfunctions of modern TV and monitors are studied in practice.
Training in the repair of power supplies for mining. 90% of the time is practical training, under the guidance of an experienced electronics engineer. Classes are held at the operating service center.